Aethra AVC500 Installation Manual download pdf (Page 38)

Monitor

In this page is possible to configure system video outputs.

You can access three menus:

• Settings

• PIP-PaP

• Plasma

Settings

In this page you can set following system parameters:

• Monitors Number

• Monitor Menu

• Video outputs

Dropdown Menu ” Monitors Number” (default setting: Automatic).

Following table shows all available configurations:

Dropdown menu

“Monitors Number”

Connected monitors

Automatic

System automatically recognises connected

monitors

XGA One XGA Monitor

TV1 One analogic monitor

TV1+TV2 Two analogic monitor

TV1+XGA

One analogic monitor

and one XGA monitor

TV1+ TV2+XGA

Two analogic monitor

and one XGA monitor.

Dropdown Menu ” Monitor Menu” (default setting: Automatic).

In case the Multi Monitor configuration has been choosen, so to have more monitors connected to the system, is possible to

choose where to see GUI – Graphical user interface.

Available configurations are:

Automatic GUI set by the system

TV1 GUI always on TV1

TV2 GUI always on TV2

XGA GUI always on XGA

16:9 check box (use only with 16:9 monitors

If selected system adds vertical side banners in order to scale fullscreen video image from 4:3 to 16:9.

16:9 selection is possible for both TV1, TV2 and XGA video outputs.

TV1: connect a monitor or an analogic TV to TV1 video output (RCA connector, point

2 of cabling scheme). 16:9

check box (use only with 16:9 monitors).

TV2: connect a monitor or an analogic TV to TV2 video output (RCA connector, point

2 of cabling scheme). 16:9

check box (use only with 16:9 monitors).

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 96 97

Comments to this Manuals

No comments

Aethra AVC500 Installation Manual Page 38

Comments to this Manuals